Installation of an air conditioner is simple in Garland TX. However, you need to make sure you have the correct date in mind. The city of Garland is located about an hour east of Dallas. If you live in another city, the name of that city should suffice to get you started. It is also important to remember the address. This is not a request to be a nuisance to another person, but to show respect for their property.
When installing an air conditioner in Garland, one of the most important things you should consider is the existing ductwork. This consists of copper tubing, which is heated and cooled by the refrigerant. Some ducts run underneath the ceiling, while others run through the walls. Most of these ducts will be easily accessible and will require little cutting so long as there is adequate pipe running back from the air conditioner to the connection point in the attic.
The contractor will need to remove and cut the old ducts before any air conditioner installation can be done. It is best if the old ones are removed before the new one is installed. Removing them gives the contractor more room to install the new one. Gutting is also a good time for any electrical or plumbing work that will need doing. This work is usually done by a general contractor. However, some electrical and plumbing work can also be done by a plumber.
If the Garland air conditioner installation includes an indoor evaporator, the new one will need to be installed over it. Most often, the installer will use an anchor to lift and install the air conditioner onto the coil. Make sure the coil’s inside edge is smooth when installing it. Otherwise the installer may damage the inner lip of the coil.
After the old conditioner has been removed from the walls, the installer must make holes in the walls. This allows the proper installation of the ductwork. The proper installation of an air conditioner depends on how large the holes are and how much room is left at its bottom. The holes must be cut deeper than the holes that were previously drilled. These screws will be secured using a few screws and an washer.
After the holes have been dug, you should clean them with mild detergent. Before the ductwork can be reinstalled, any oil or dirt must be removed. A plastic or metal tube that was used to install the blower should be removed. This will make the air conditioner cool and more efficient during installation.
The air conditioner installer will then position the air conditioner blower onto the blower post. The blower will then be attached to the post with screws and a washer. The blower will then need to be attached to the blower post with another set of screws. The ductwork can be connected if the existing air conditioner has been vented. The ductwork needs to be connected to the air handler, which is located outside of the home.
After the installation is complete, it’s important that the homeowner turns the thermostat back on. Most HVAC companies will ask the homeowner this before beginning the new air conditioner installation process. During the entire installation process, some HVAC companies will disconnect power from the home. This ensures that the system works properly. After the installation is complete, a professional HVAC contractor can turn the power back ON.